ble_lesson5_rgbled




YouTube 影片




App Inventor

Designer

Blocks

Arduino 101

 #include <CurieBLE.h>
#include <stdlib.h>
#define LEDr 6
#define LEDg 5
#define LEDb 3

BLEPeripheral blePeripheral;  // BLE Peripheral Device (the board you're programming)
BLEService ControlLED("19B10010-E8F2-537E-4F6C-D104768A1214"); // BLE AnalogRead Service

// BLE LED Switch Characteristic - custom 128-bit UUID, read and writable by central
BLEUnsignedIntCharacteristic LEDStatus("19B10011-E8F2-537E-4F6C-D104768A1214", BLERead | BLEWrite  );

int incom = 0;
int r, g, b ;


void setup() {
  Serial.begin(9600);
  // set Light pin to output mode
  // set advertised local name and service UUID:
  blePeripheral.setLocalName("ControlLED");
  blePeripheral.setAdvertisedServiceUuid(ControlLED.uuid());

  // add service and characteristic:
  blePeripheral.addAttribute(ControlLED);
  blePeripheral.addAttribute(LEDStatus);

  // begin advertising BLE Light service:
  blePeripheral.begin();

  Serial.println("BLE AnalogRead service.");

  pinMode(LEDr, OUTPUT);
  pinMode(LEDg, OUTPUT);
  pinMode(LEDb, OUTPUT);

}

void loop() {
  // listen for BLE peripherals to connect:

  BLECentral central = blePeripheral.central();
  // if a central is connected to peripheral:
  if (central) {
    Serial.print("Connected to central: ");
    // print the central's MAC address:
    Serial.println(central.address());


    // while the central is still connected to peripheral:
    while (central.connected()) {
      //Serial.println(LEDStatus.written());


      if (LEDStatus.written())
      {
        incom = LEDStatus.value();//110225101/255
        r = incom / 1000000 ;//110
        g = (incom / 1000 - r * 1000) ; //110225-110000=225
        b = (incom - r * 1000000 - g * 1000) ; //110225101-110000000-2250000=101
        Serial.println(incom);
        Serial.println(r);
        Serial.println(g);
        Serial.println(b);
        analogWrite(LEDr, r);
        analogWrite(LEDg, g);
        analogWrite(LEDb, b);
        delay(10);
      }
    }
    pinMode(LEDr, LOW);
    pinMode(LEDg, LOW);
    pinMode(LEDb, LOW);
    delay(100);
  }

  // when the central disconnects, print it out:

  Serial.print(F("Disconnected from central: "));
  Serial.println(central.address());
}


ċ
BLE_Arduino101_RGBblink.ino
(2k)
曾吉弘,
2017年1月4日 上午6:31
ċ
getPixelColor_BLE.aia
(241k)
曾吉弘,
2017年1月9日 下午9:48
Comments